Brake booster and wheel bearing hub promble

[mugen24]

Hi
Does 1999 HONDA Integra Gsi Automatic share a same brake booster with B16A EG civic? Can i just swap the booster between these two cars?

Also the wheel hubs....can i swap to each other?

Thanks :)

[riruiz_88]

from what i gathered from OH, it dosnt matter if the doner car is auto/manual. but just in case i would be going for the manual version. also you should really go for the Vti-r brake booster/mast cylinder combo, all bolt in. as for the hubs, yes the DC2 is compatible for the EG. but you will need the whole lot from the DC2, including: knuckle, rotors, caliper, (hub is already on the knuckle). if your referring to the front?

[bennjamin]

same brake booster yes.

also the same front and rear brakes. That includes disc size , caliper size , knuckle etc.All compatible.

[mugen24]

ok...the thing is my B16A eg civic brake booster has a little bit leaking and the left hand side wheel bearing need to replace....at the same time my frind got a 99 DC4 Gsi he doesnt drive it....so i just guess to swap the parts to my EG and then put my faulty ones to his integra...
will that cost a lot to the labour?
for the wheel bearing...which part of the brake system should i swap?
Thanks

[riruiz_88]

you may as well get the complete front end, hubs i mean for both sides. its fairly easy to swap the parts over, but if you know that you cant do it then get someone who knows how do it.

[mugen24]

ok, thaks and i also want to know what else are compatible between DC4 Gsi integra and B16A EG civic sedan...
engine mounts? lower control arm?....what else...

[bennjamin]

if its an actual EG9 (import b16a sedan) then almost everything is compatible.
Same mounts , almost all suspension is the same , same brakes etc.

[mugen24]

No, it is a Aus deliver EG civic sedan si (1.6L original) with B16A conversion....
And the DC4 integra is Gsi (not vtir and type r at all)
Thanks

[bennjamin]

ok if its the Si , and nothing else has been changed apart from the engine , then only the suspension parts and rear brakes are the same. Front knuckles + brakes and booster etc are slightly different

FYI the dc4 has the same brakes as the vtir , front n rear. And majority other parts are the same too.

[mugen24]

alright.
so in this case i cant swap the booster and wheel hub between these two cars??
I know the DC4's can go to the si civic....but i am just worring the parts from civic to DC4 integra.

[bennjamin]

yes you can swap them , but essentially if you swap the civic bits to the dc its downgrading. Make sense

[mugen24]

the thing is i can swap them without any problem...in one word, they works to each other, right?
If yes...i am gona to swap them.
Thanks a lot, bennjamin and you guys.

[bennjamin]

yes they will 100% work with each other.


You might need to slightly bend the hard brake lines to fit either master cylinder

[riruiz_88]

same as the calipers from the DC2 goin into the EG. you will find that the EG brake line is about 3-5mm too short, so you will have to stretch it ever so gently to make the banjo bolt fit into the caliper.