Reverse Gear problem with my DC2R?

[typerdevil]

Hi peoples

I recently just noticed, that when i put my car into reverse before taking off, it jolts and makes that noticeable sound when gearing into reverse before take off, i have no idea what is causing this problem, it's worrying me...
any clues what is causing this problem?


Also i gave it a squirt today as in vtec and i tried to get it into 5th gear it was getting stuck and before you know it, i started mashing some of the gears were hard to gear down :confused:, so i pulled over, smelt like something was burning.....obviously i wasn't racing the gears, quick shifting, it failed today anyways, it would be good if some people here would answer the above question to my problem...

[arron]

Change your transmission fluid. That solves over 50% of gearbox issues.
If the problem still exists, check engine mounts for wear or hairline cracks.
Change engine mounts.
If that's still not the problem, say hello to new syncros/gears!

[VTECMACHINE]

Are you sure you still have G/B fluid, and it hasn't been leaking from anywhere, like your driveshaft seals?

Check and change your g/b oil. Follow the steps arron says above.

[aaronng]

Is your clutch biting point at the bottom near the floor? If yes, then bleed your clutch line a little bit. Your clutch might not be fully disengaging, hence you get that jolt when you put it into gear.

[kevster]

could also check clutch slave cylinder. that could be affecting gear changes also