PDA

View Full Version : Ultra racing front strut bar for Civic FD


ej20i
07-11-2008, 11:26 PM
Disclaimer: The following are provided as a GUIDE ONLY, and neither myself. nor the original writer, nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!


Just a guide to install an Ultra Racing front strut bar in a Civic FD

Step 1: Buy the bar hehehe
http://i193.photobucket.com/albums/z257/ej20i/DSC_0003.jpg

Step 2: Open the packaging
http://i193.photobucket.com/albums/z257/ej20i/DSC_0006.jpg

Step 3: Open the cover for the suspension point by just pulling it off
http://i193.photobucket.com/albums/z257/ej20i/w.jpg

Step 4: Pull the clips off the cover for the strut bar
http://i193.photobucket.com/albums/z257/ej20i/DSC_0014.jpg

Step 5: just pull the cover off...its a bit hard but they r just clips and position the strut bar like so
http://i193.photobucket.com/albums/z257/ej20i/DSC_0018.jpg

Step 6: Tighten the nuts supplied by the bar to the existing screw holes in following postion
http://i193.photobucket.com/albums/z257/ej20i/DSC_0021.jpg

and just reversed all the steps back to put all the trim back and thats all

heres the finished result

http://i193.photobucket.com/albums/z257/ej20i/DSC_0024.jpg
mugenrr
07-11-2008, 11:31 PM
The best 1 & 2 Steps hahaha !!
serzly these bars are hektic!
squish85
08-11-2008, 01:56 AM
cool.. strut bar stays hidden..
Shimian
16-11-2008, 09:02 AM
you forgot to add when removing the black cover, theres a bits and pieces of the plastic you need to move around before it comes off. The ends of the cover has flaps that slots into places.

Was there a piece that you had to totally remove on the drivers side? Or else the cover will not close once the strut has been installed.
eNGee
11-01-2010, 09:56 AM
you forgot to add when removing the black cover, theres a bits and pieces of the plastic you need to move around before it comes off. The ends of the cover has flaps that slots into places.

Was there a piece that you had to totally remove on the drivers side? Or else the cover will not close once the strut has been installed.

I installed my Ultra Racing bar last night ^.^

Correct. There are separate rubber bits you gotta put back. However, it's very easy to do. I pretty much followed these steps and no dramas.

Correct again. there was a piece of plastic that you had to totally remove as the strut bar blocked it's previous spot. Once again, no dramas. All ya gotta do it get a phillips head (x) screwdriver and take out two screws and then pull the plastic bit off. Once you've done that you're all sweet!

Thanks heaps for the write up, it was tremendously helpful!!!
bernstar69
18-03-2014, 04:43 PM
hey, what kind of bolts or nuts do you use? i bought mine 2nd hand, didnt come with nuts
androo
20-03-2014, 07:42 PM
Did you notice any difference? You should post a review!
Honda_FD
22-03-2014, 11:28 PM
hey, what kind of bolts or nuts do you use? i bought mine 2nd hand, didnt come with nuts

You use the nuts on the struts...
nedkerry
02-04-2014, 07:09 PM
Did you notice any difference? You should post a review!

Also curious about this.