how to remove dc2 rear seats

[AznTeg]

Hey all.. jus cleaning out da whole car da other day.. n wanted 2 fix up n tighten seatcovers.. did a search on here.. didnt really find any info besides 4 civic n teg LS... (not sure if its da same 4 all dc2s inclu ITR.. ) found dis link: http://hadriver.org/forums/showthread.php?t=11547 deres pics from "Tegger"s link ... Note: l8r on inda thread .. ppl talking bout da thefts n sh*t dat goes on inda US.... ccrraaazzzy *mods move if not in right section... thanks.. hope it helps sumone out dere.. :)

[T-onedc2]

I did it once to clean it out, I think it was as simple sliding your hand behind the rear of the bench and tilting it upwards. Then the front either just unclips, or has a couple bolts, can't quite remember sorry.

[dudeling7]

Tilt both of the seats down by lifting the knob on either side of the seats.

Then on each end of the seat you just tilted and near the bottom you will see a little black clip which looks like a U shape with a little point in the middle. Pull that little clip off both sides and then you can pull the top portion of the seat off by wiggling it either left or right then pulling it up.

Next, after lifting the top portion of the seat it will expose a bolt which the bottom portion is bolted into the chassis with. its prob a 10 or 12mm bolt just undo it.

then as Tonedc2 said, i think you lift the rear of the seat first then pull the whole seat base off by lifting it out of the holes in the bottom.