HELP with DIY

[amirul]

Hey, does anyone know how to take the rubber/plastics seal near the soft top @ back??

is it juz clip on, clip off thing like the door window seal??

anyhelp greatly appreciated:thumbsup:

[MRK-01]

can you explain a little better..? I replaced my 01 roof with a glass 02 roof. following the guides in the honda tech manual you can find on this forum. but basically to get the rear of the roof off, you need to get the seats and interior paneling out to get to the bolts and pop rivets holding the rear of the roof to the rear panel.

You should also notice around the plastic window should be velcro covering a zip to detatch the rear window....

cheers
mrk

[amirul]

nah not replacing roof, i meant this part here........rubber/plactics moulding wat ever u call em, im not 100% sure lol.......

http://img376.imageshack.us/img376/1429/img2758oq8.jpg

[MRK-01]

I am pretty sure this is a part of the roof's guttering.

When you take to rear section of the roof off, you have a "gutter" made of plastic with drainholes near the doors. This is held on behind the rollbar interior panels.

The panels all link into one another, so you need to get the seats out first, then work to the back from there.

The Roof and guttering are all connected at the same points by bolts and rivets., then there is the Black plasic seal thingy. I am pretty sure this is what I saw when I did mine. Check the manual out. Its Called "Honda S2000 (00-03) Service Manual.pdf". It will show you how to and what you need to get to it.

Hope this helps.

MRK

[MRK-01]

I just checked the service manual. It does seem to get the moulding out correctly you need to remove the roof..!!:thumbdwn::thumbdwn:

You can get the manual from this thread...see page 20-55
S2000
Logbook, Service & Maintenance Information

99-03 Service Manual
http://www.ozhonda.com/forum/showthread.php?t=45287

[NVD52K]

you have to remove the roof for that plastic man lol thats a big job