retro fitting ap1 ballast into ap2 headlights

[sho]

Not sure if this has been covered or not but i found out a way to do this without cutting the head lights :)

all you need to do is disconnect the wires that runs into the connector, run the wires in that hole and reconnect it back into the connector on the other end :)

it saved me a bit of time trying to cut the hole bigger with a dremel :)


http://i6.photobucket.com/albums/y207/drs13t/Resized_DSC_0302.jpg

http://i6.photobucket.com/albums/y207/drs13t/Resized_DSC_0305.jpg

http://i6.photobucket.com/albums/y207/drs13t/Resized_DSC_0298.jpg

http://i6.photobucket.com/albums/y207/drs13t/Resized_DSC_0301.jpg

http://i6.photobucket.com/albums/y207/drs13t/Resized_DSC_0304.jpg

[zero33]

nice post...

didn't see it that way.. i tried from the other end..

=)