switching from stock dc2 wheels to rota

[fabian0]

hey guys, my car is currently on stock wheels as shown in the picture below

http://i35.tinypic.com/mb69gl.jpg

i'm thinking of getting some rotas, probably slipstream or circuit8. Would a 15x6.5 Rota Slipstream, White, 4x100 40MM fit my car without any problems? i'm not sure about the bolt size thingy etc.

also when getting new tyres on this rims, does the offset matter?

cheers

[Lukey]

hey guys, my car is currently on stock wheels as shown in the picture below

http://i35.tinypic.com/mb69gl.jpg

i'm thinking of getting some rotas, probably slipstream or circuit8. Would a 15x6.5 Rota Slipstream, White, 4x100 40MM fit my car without any problems? i'm not sure about the bolt size thingy etc.

also when getting new tyres on this rims, does the offset matter?

cheers

yes that will fit

and tyre dont have anything to do with offset

id suggest 195/50 or 195/55 tyres

or even perhaps 205 tyres

[SHOGUNOVDDRK]

Yes the rims will fit without a hitch.

Good luck and keep us posted

[EG30]

yes will fit mint, your wheels atm are 15x6 ET45, going to 6.5" and extra 5mm offset the wheel edge would sit a further 11.35mm towards the outside and fills the guard better.

make sure you get the hubcentric ring that steps down from the rota's centre bore of 73.1mm down to the 56.1mm hub size for your honda if they are not supplied with the rim.

in terms of tyres for an integra, go for 195/55 or 205/50 depending on your pref, budget. 205 works and looks better on 7" rims, 195 a better match for the 6.5" rims.

[vinnY]

just to clarify, to calculate the fitment you halved the increase/decrease in width and add/subtract the difference in offset?

[lil_foy]

Thats correct.

Just go to google and type in "offset calculator"

[lil_foy]

Just to add, if you can get abit wider wheel and lower offset.
Im running 7.5 wide with a +40 offset and mine are fairly flush with the guards.

Makes the car look alot better imo.

Feel free to pm me if you need anymore help.