View Full Version : ITR intake manifold on VTI-R
stephbean
15-12-2008, 09:34 PM
hey guys...
i was wondering if any of you guys can help me out...
if i have the ITR IM...could i put it straight onto my b18c..
or is there a few adjustments required...?
thanks
it wont fit different sizes
u need either a skunk2 manifold or get a whole itr head i think to make ur itr im fit
geeang
15-12-2008, 11:59 PM
it wont fit different sizes
u need either a skunk2 manifold or get a whole itr head i think to make ur itr im fit
He's right, the ITR manifold will not fit onto a VTIR head.
Your only options are to get an ITR head, or sell your ITR manifold and get a Skunk2 or other aftermarket one.
kraiye
16-12-2008, 05:35 AM
hey guys whats different between the B18C2 and B18C7 that will stop it from fitting?
just curious
TODA AU
16-12-2008, 07:28 AM
Bolt holes at either end (you could elongate these)
& Port angle...
stephbean
16-12-2008, 10:29 AM
thanks for your help guys..legendss!!
vinnY
16-12-2008, 11:39 AM
elongate the end holes.. i'm guessing this is how skunk2 manifolds are made to suit both the p72 and pr3 heads at once?
any ill effects regarding the port angles if you did make the pr3 manifold to fit the p72 head?
fatboyz39
16-12-2008, 12:24 PM
hey guys...
i was wondering if any of you guys can help me out...
if i have the ITR IM...could i put it straight onto my b18c..
or is there a few adjustments required...?
thanks
Wont fit. Buy aftermarket one i.e BLOX, SKUNK2 and etc
i-jrdm
16-12-2008, 06:31 PM
wont fit.
need to modify the manifold. not too hard but yer more messing around.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.