helps with lowering a car

[denrie]

hey guys im lowering my car this friday.. on k mac springs...

3 inch front and 2.5 at the rear..

can anyone help me where exactly it will dropp?

like if theres any pictures that could be posted to see where they sit..

thanx guys !

[spuderump]

itd drop depending on how much is cut of the springs and really how low do you want it?

[vinnY]

3in at the front and 2.5in at the rear?
if anything it'll sit higher for the few few days until it settles in

[mars_panas]

it will probably be roughly 1 finger gap.... but as vinny mention it will sag a little more once it settles down

[denrie]

sorrry its a civic sedan eh9

[denrie]

any pics guys?

[OMG.JAI xD]

i reckon you wont even get 1 finger gap with 3" drop in the front.

[denrie]

yeh im not intending a conversion just wanna go really low.... just wanted to see where the back will drop..

[Zdster]

Am I missing something here? :confused:

Measure 3" and that is how much it will drop.

[mars_panas]

i believe it will lower 1 finger gap after the sagging of the springs but when u freshly put it on it will be 2 finger gap maybe a bit more

[mr_kentu]

your inbox full mate.
wellm im running stock suspension with cut off skunk2 springs. coz on the website it stated that it will drop 2.25 rear and 2.5 front. but after installed it still really high.(about 3 fingers high)so decided to cut those off. m not sure how many inch i cut as i did that step by step till i found good....so i cut couple of CM for all of those springs...install it... and re-do it again till i found good... probably about 4 times...
how low your car will is depending on how many inch is your rims.

[AE092]

denrie, i've got custom wound Kmac springs on my corolla, roughly the same height as what you've stated. If you want pics, PM me

[denrie]

thanx guys.. just if there are pikz on civic eg/eh

[Gio]

lol at cutting spring omg, so unsafe.

[4age8u]

cuttzz G