crx999
26-12-2008, 02:53 PM
Just wondering if anyone can reccomend where to purchase a set of 4-1 headers for my D16a8 CRX motor. I realise that doing this will result in a loss of torque down low, but being a circuit racing car very rarely below 4000rpm - am very interested to carry out some back to back Dyno work & see the losses & gains over my existing system, if any. Any contacts that are given would be greatly appreciated. Ideally someone in Australia would be preferred.
Thanks again, looking fwd to reading your feedback.
Thanks again, looking fwd to reading your feedback.