monda2
22-01-2009, 07:17 PM
Hey All
Could someone please let me know where the below circled outlets go?
Iam using a B16A1 but the thermostate housing is off a later engine, B16A2 i think, this is due to the fact iam using a OBD2 ECU and loom which required the later housing and a few other changes.
left - does this connect to fuel injection manifold? has this been cut at some stage as it has the angle onit?
middle - does this connect to fuel injection manifold?
right - is this a heater outlet? If so, is it ok to plug as iam not having a heater?
http://i51.photobucket.com/albums/f386/benmin/vtec3.jpg
Could someone please let me know where the below circled outlets go?
Iam using a B16A1 but the thermostate housing is off a later engine, B16A2 i think, this is due to the fact iam using a OBD2 ECU and loom which required the later housing and a few other changes.
left - does this connect to fuel injection manifold? has this been cut at some stage as it has the angle onit?
middle - does this connect to fuel injection manifold?
right - is this a heater outlet? If so, is it ok to plug as iam not having a heater?
http://i51.photobucket.com/albums/f386/benmin/vtec3.jpg