DIY GruppeM / K&N Air Filter Maintenance

[XP02ED]

Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!


Aim: Cleaning GruppeM / K&N Filters
Required: K&N Filter kit
Steps:

STEP 1. Remove the filter from the vehicle cleaner case, and use a soft brush to get rid of large dirt particles.


http://gruppem.co.jp/images/Clean1.jpg
STEP 2. Spray liberal amounts of the filter washer fluid on the filter, and let stand for 30 minutes (adjust the length of time according to the degree of dirt build-up).


*Note : Do not use high-pressure washing, steam cleaning, or solvents such as part cleaners, or gasoline, as these may damage the main body of the filter.

http://gruppem.co.jp/images/Clean2.jpg
http://gruppem.co.jp/images/Clean3.jpg

STEP 3. Rinse the filter from the engine side to the outer side using a gentle stream of water (be sure to avoid strong water pressure). After that, shake off all the excess water and let it dry in the shade.


*Note : Do not attempt to accelerate drying with an air compressor or drier, as the main body of the filter may become damaged and unusable.
*Repeat steps 2 and 3 until all the dirt has been removed.

http://gruppem.co.jp/images/Clean4.jpg
http://gruppem.co.jp/images/Clean5.jpg

STEP 4. After it has dried, lightly spray the filter oil along the filter pleats from the outer side. Be careful not to apply too much oil as it will further penetrate and permeate the entire filter when left to sit for 5 minutes. If there still appear to be white spots after this time, lightly sprays those areas again.

If oil other than the special filter oil is used, such as ATF, engine oil, gasoline, light oil, or lubricating oil, it may result in damage to the filter or cause engine problems. Only the special filter oil can be used. Also do not use the filter under any circumstances if the oil has not been applied.

http://gruppem.co.jp/images/Clean6.jpg
http://gruppem.co.jp/images/Clean7.jpg

STEP 5. Replace the filter on the filter case and the job is complete.
If it is a Replacement part, wipe the inside of the cleaner case before replacing the filter.

http://gruppem.co.jp/images/Clean8.jpg
http://gruppem.co.jp/images/Clean9.jpg


Other comments : TAKEN FROM gruppem.co.jp

http://gruppem.co.jp/en/maintenance.html

[cupnoodle]

STEP 1. Remove the filter from the vehicle cleaner case, and use a soft brush to get rid of large dirt particles.

Thanks for the DIY.

Any DIY on how to remove the filter from the carbon housing? I purchased my DC5R with the intake pre-installed. So i got no idea how to work backwards

[XP02ED]

There should be 2 Allen Key type bolts on a metal claps.

Just remove them and your filter should be remove along with the carbon housing.

To be specific see the metal clamp on this photo, u just need to remove that


http://xposed.au.com/photos/resized/19/1177468136_DSC01617.JPG

[cupnoodle]

Awesome! Will give it a try tonight. Rep +1

[mrwillz]

i need to do this badly on my k&n pod
didnt realise how dirty it can get when the pod is down at the front of the bumper

[mrwillz]

did this to my pod
what a difference it made

my pod was filled with black stuff everywhere

i got the bottle of oil with my k&n pack
makes it nice n red after

[WuackR]

Will this process work on a mugen ? using mugen products also ?

[R123]

Anyone know how often should they clean their GruppeM filter?