an ef9 front on a ed sedan

[jimbram__]

hey guys just wondering that would a ef9 front bar would fit on ed sedan
or do i have to change the hole front !

[vietmofo]

i think you would have to change the whole front...ive seen photos where ppl were able to get the front bar to fit on but thats on hatches, probably be able to with the sedan...=S

[VTi_b0i]

u need to change the WHOLE front end dude...guards, bonnet, bumper support, bumper, head lights, corner lights lol

[trism]

the bar will fit, but the the complete front end youll need headlights/corners, bonnet, guards, apron (the part that sits between the headlights and bumper)

people say that you need to rad support/bumper support but im sure ive seen people do it without needing to change this

[Limo]

to get everything to fit properly (flush) you need to change the whole front end.

[jimbram__]

so u dont acully have to change the whole front to make it fit u can lyk wack on the bar ?

[pat88c]

as above posts yo need

guards, bonnet, bumper support, bumper, head lights, corner lights
the front of ef jdm is about 10 to 15mm wider ????


as shown in this diy for b16a vtec into crx which almost same



http://www.ozhonda.com/forum/showthread.php?t=46374&highlight=crx%2C+b16a (http://www.ozhonda.com/forum/showthread.php?t=46374&highlight=crx%2C+b16a)