b18c5 front cut [Archive] - Ozhonda Forums

Baopham

25-10-2004, 12:21 AM

does anyone know where i can find myself a integra type r front cut? and how much for it? ive looked everywhere i can for it.. anywhere in australia, but if its not brisbane, could u tell me frieght costs aswell?? thx

spoondc2

25-10-2004, 01:37 AM

Well....... i really think it's impossilbe to find a type-r front cut in here, but if you can really find it, i will be interested of the front lip

anyway, did you try hondarec?

DCLXVI

25-10-2004, 02:23 AM

wats your budget like.. if u have much, get it from states.. sites like SOHFAST.com or importautosalvage.com may have some. I have tried much of the japs importers here.. so far none have eg6 cut let alone teg type r cut. good luck with the project. :)

jimmeh

25-10-2004, 04:53 AM

ur not looking hard enuff. i along with MRJDM had 3 type r motor at one stage. frieght should cost 500

dc2r

25-10-2004, 07:05 PM

You're looking for a B18C7... unless you want an American Type-R engine? :)

Jase EK

24-08-2005, 09:54 PM

im lookin for one

chinkdood

24-08-2005, 10:36 PM

pm EG5 or email him yonas@jdmyard.com
im prretty sure he can help u.

57UDD

25-08-2005, 09:22 AM

i'll ask my friend at alljap, it wont be as expensive as if u were to go yourself, should get it much cheaper. I'm lookin one myself to put in a eg hatch.

Felix

25-08-2005, 12:57 PM

about $6000

TYPE-R617

25-08-2005, 01:50 PM

You're looking for a B18C7... unless you want an American Type-R engine? :)

can u tell me wats da diff between B18C, B18C5 and B18C7 please?

jonotan

25-08-2005, 04:06 PM

http://www.japandirect.com.au/usedparts/Engine%20&%20half%20Cut/index.php

try this.

z3lda

25-08-2005, 04:17 PM

can u tell me wats da diff between B18C, B18C5 and B18C7 please?

B18C1 - US spec GSR (VTi-R)
B18C2 - AUS spec VTi-R
B18C3 - Spoon SiR-G / JDM
B18C4 - UK spec VTi
B18C5 - US spec ITR / some sources refer to exist as JDM as well
B18C6 - Euro spec ITR
B18C7 - AUS spec ITR

B18C - JDM ITR and JDM SiR-G/VTi-R only way to tell is if you look at the head and inlet manifold

Lots of different variants as you can see

TYPE-R617

25-08-2005, 04:28 PM

thanks dude. :thumbsup:

spardikis

26-08-2005, 10:18 PM

guys guys guys... import from nz, its all JDM over there the whole of the country drives imports and most of them are pretty good and hell cheap, never mind getting the stuff all the way from the states, and im sure that JDM stuff is better tuned anywayz...

http://www.stronghonda.co.nz/

http://www.ozhonda.com/forum/showthread.php?t=259&page=2&pp=12&highlight=strong+honda