PDA

View Full Version : Can someone help me out? ENGINE LIGHT



hectik_7
13-03-2009, 05:26 PM
Ok,

So i got my headers installed, all is sweet, except...

The engine light is on?

What's going on, everything is normal, car goes fine and all, except for this light..

Can anyone shed some light please?

Thanks..

Frankie
13-03-2009, 05:32 PM
make sure that the air sensor that is connect to the intake is connected properly, take it out and give it a clean and reconnect that might work

hectik_7
13-03-2009, 05:36 PM
ahh,, how do i do this?

I think that might be it..

Obviosly i need to get under that car.. no worries..

but where is it exactly, is this why its the engine check light is on?

The car is 100% functional..

Frankie
13-03-2009, 05:39 PM
http://s213.photobucket.com/albums/cc39/nicksuth/?action=view&current=CamshaftandAirSensor.jpg
its looks a bit like that and it is the only electrical wire that is goign into your intake all you have to do is unplug it and clean give it a blow or wipe it and reconnect ti

AKmotorworks
13-03-2009, 05:48 PM
if you have just installed headers, the likely culprit would be the o2 sensor.

aaronng
13-03-2009, 06:10 PM
Agreed, check the O2 sensor wiring. You might have kinked it or damaged the sensor.

hectik_7
13-03-2009, 06:18 PM
Oh k,

Is there anyway i can remove it or clean it?

Or would it need replacing? I think i should take it back to the exhaust shop...

hectik_7
13-03-2009, 06:33 PM
BUMBING THIS UP,,

i hate this f**kn light

Frankie
13-03-2009, 06:51 PM
my mates car has the same, get an ecu that has programed all your modification that will fix it

AKmotorworks
14-03-2009, 10:49 AM
you can do a resistance value check, but its probably most cost effective to simply replace it.

Before you go and do that though, do a diagnostic on it to make sure its the 02 sensor. Theres a DIY on how to do that on thsi forum somewhere

GSi_PSi
14-03-2009, 07:01 PM
who installed the headers? did they unhook the stock 02 sensor and remove the plug from the factory headers and fit onto the new ones>?

aaronng
14-03-2009, 07:03 PM
Like AKmotorworks said, get a paperclip and read the code.
DIY: http://www.ozhonda.com/forum/showthread.php?t=67113

hectik_7
16-03-2009, 03:50 PM
Updates. . .

Im yet to do tha diagnostic check. .

I got underneath tha car and took of tha o2 sensor and cleaned it put it bak on.. .
Now tha car idles better and sounds smoother but, tha light is stil on.

Il do tha diagnostic chek n update this thread. . Does ne1 have more ideas or soloutions?

Thanks ppl

aaronng
16-03-2009, 04:19 PM
Diagnostic check first, then post back the code. Nothing else you can do until then.