Tacho and Speedo not working??:confused:

[MacDiZZle]

Hey guys not sure if you can help me but my speedo and rpm gauge is not working

It was fine last night and then i just came out thismorning and they were both dead! its a b16a out of an eg...

about a month ago my speedo only stopped working and i replaced the speedo sensor which fixed it up good. but now both it and the rpm gauge have stopped. any ideas??

[Chriskoss]

Sounds like blown fuse as its too much of a coincidence for them to both go at the same time. Replace both the fuses and see how it goes

[MacDiZZle]

na its not i tested them all... could it be the console?? its out of a dc2 but some stuff isnt working on it like the handbrake light and others are like the fuel and temp. i might rewire it coz its real dodgy at the moment.

Does anyone have a wiring diagram for a dc2 integra dash?

[Chriskoss]

Well if the wiring is dodgy then theres your problem could of caused a shorted out circuit which can damage the wires, and if you have damaged wires theres no other way of fixing it besides re-wiring

[MacDiZZle]

fixed it... a part of the circuit board was rubbing against the back of the dash and it was cut. i just bypassed it with some wire :) dodgy lol thanks mate.