View Full Version : DIY (request) EG sedan bumper removal
hectic_filo
03-07-2009, 02:25 PM
HI honda lovers, Need help removing the factory front bumber, rear bumper and side skirts.
I wanted to install the bodykit that i bought for my civic EG sedan
thanks
I think this is in the wrong section, but....
Front bumper has some screws just under the front of the hood, one bolt at each fender, and 2 bolts just at the bottom of the car.
Side skirts have screws on the bottom and ends I think, and then it slides off.
Rear bumper is setup like the front, screws under the trunk, one bolt at each rear quarter, and 2 on the bottom of the car.
hectic_filo
03-07-2009, 07:16 PM
I think this is in the wrong section, but....
Front bumper has some screws just under the front of the hood, one bolt at each fender, and 2 bolts just at the bottom of the car.
Side skirts have screws on the bottom and ends I think, and then it slides off.
Rear bumper is setup like the front, screws under the trunk, one bolt at each rear quarter, and 2 on the bottom of the car.
i know its in the wrong section i posted one like this in the DIY request sub forum but no body replied back but u did reply in this one
thanks for the information. I am goin to remove it this weekend :)
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.