conversion nooby question

[mugenrr]

Hey guys,

Just wondering when transfering an ITR halfcut including the loom and dc2 dash into an eg civic, would it be a matter of straight plug and play as it was on the halfcut since you are using the ITR dash?

Thanks guys

[mugenrr]

anyone?

[mugenrr]

anyone home? :)

[MikeyG]

the white eg k20a has done a dc2 dash conver into a eg.. i dont tihnk it would be plug n play for the dash BUT engine wise..

you need obv

engine, box, ecu, loom, obd2 or sumting harness for the ecu, rear brackets, upper raditator hose, b series driveshaft :)

hope that helps.. btw most of the stuff i listed comes with half cuts i believe!

[mugenrr]

the white eg k20a has done a dc2 dash conver into a eg.. i dont tihnk it would be plug n play for the dash BUT engine wise..

you need obv

engine, box, ecu, loom, obd2 or sumting harness for the ecu, rear brackets, upper raditator hose, b series driveshaft :)

hope that helps.. btw most of the stuff i listed comes with half cuts i believe!

ah k , just the dash will need modifications then.

Thanks

[MikeyG]

npz one of the build threads has a white eg doing a k20a conversion he has done the dash pm him about it

[timster1200]

It will work dash conversion and all. But it wont look that good, there will be slight gaps here and there and everywhere. If you really want to put it in, from afar it will look good, but when up close and personal you will see the cluster doesnt match up, and the dash overlaps.

check this for info on the cluster fitment:
http://www.ozhonda.com/forum/showthread.php?t=112261&highlight=dc2+cluster+civic

check this for some info on dash fitment:

http://www.ozhonda.com/forum/showthread.php?t=45991&page=6

These show you it's possible, but a bit of a pig of a job to do, and they will never sit perfectly flush for you.