Recommendation in situation

[craze]

Hey guys i recently installed toda headers and cat and the cat is touching my LAB atm and its causing some rattling when stationary and at low rpms. Do you think if i wrapped the LAB where the cat is touching this will cause the rattle to go away? Or even better any suggestions on what to do? Or should i just take off my LAB to solve the problem?

[integral90]

How hard is the rattle? Also does it bang when you go off the throttle quickly?

[aaronng]

Reweld so that the cat sits further away from the lower arm bar. Or just remove the lower arm bar.

[craze]

How hard is the rattle? Also does it bang when you go off the throttle quickly?

Doesn't bang because its sorta sitting on the bar there is no space between the bar and the cat

[integral90]

Doesn't bang because its sorta sitting on the bar there is no space between the bar and the cat

Well seeing as your engine shifts and tilting in the engine bay I thought there might be a chance it was banging :p

Still though, if it's just constantly pushing against it regardless of engine tilt, I'd lose the LAB

[yfin]

I put large washers on the long bolt and it solved my rattle - and you can keep the lower arm bar

[hooyn]

how much did you pick up the header for?

[TODA AU]

Or should i just take off my LAB to solve the problem?

Yes...

[craze]

Thanks guys i will take the bar off