DC2R Suspension fitment

[tran06]

Hey,

I'm not too sure whats required to fit DC2R suspension into a DC2/4.

I know that you have to change the rear lower control arms to a DC2R one, but are there other things that I need to know?

[jeffreymui]

just the LCA that u have the change from my knowledge

[tran06]

so the front shocks from ITR fit normal DC2's fine?

[vinnY]

yes fronts will fit fine
rear will fit as long as you have dc2r/eg6 rear lca(to go from fork to eyelet)

[ninzee]

yea only lca's 100% i did it 2 my eg5 and dc2 n eg5 have same sussy arms

[tran06]

do the brackets for the swaybar on the LCA of a normal DC2 line up with a DC2R ones?

[T-onedc2]

do the brackets for the swaybar on the LCA of a normal DC2 line up with a DC2R ones?
Yes front and rear endlinks are all interchangeable, but no, the rear brackets won't. You'll need either Beaks or ASR reinforcement kit. ASR is easier and looks good. I have Beaks.

[tran06]

Hmmm,

So changing the LCA's to ITR ones, I'd also have to change my whole rear sway bar setup?

[ninzee]

doubt it not 100% though

[geeang]

If you simply got DC2R LCA's, then you can use the stock DC2 GSI/VTIR swaybar.
If you got a DC2R swaybar, then you would need ASR/Beaks to fit the brackets as T-onedc2 has said.

[T-onedc2]

^^^correct^^^