b series rear mount bracket

[vinnY]

anyone happen to have a picture of said bracket attached to the motor? i can find pictures of the bracket but none attached to the motor

[bennjamin]

the bracket is only attached to the TOP via 1x 17mm headed bolt. The majority of the bracket is connected to the rear of the diff housing , via 2 x 19mm headed bolts.

Sorry no pix tho !

[vinnY]

yeah i found it in the service manual but i just wanted to check it out with colours hehe

[Limbo]

its hard to see it cos its a tight one.

[vinnY]

with so many engine swaps happening you'd think someone would have a photo :p
oh well will keep searching

[bennjamin]

with so many engine swaps happening you'd think someone would have a photo :p
oh well will keep searching

what exactly are you asking for tho lol ?

[vinnY]

just a photo of how the bracket is mated to the motor/tranny
i have an idea, just wanted to confirm my thoughts
and whether i can actually reach said bolts from under the car to tighten them(two bottom ones i'm assuming i can since you have to undo them to remove the tranny, not too sure about the above one)

[bennjamin]

just a photo of how the bracket is mated to the motor/tranny
i have an idea, just wanted to confirm my thoughts
and whether i can actually reach said bolts from under the car to tighten them(two bottom ones i'm assuming i can since you have to undo them to remove the tranny, not too sure about the above one)

to remove the tranny...you must remove the 3 x bolts holding it to the gearbox and engine. 1 x 17mm head and 2 x 19mm head.
The 2 x 19mm are easy to see and fairly easy to access - the 17mm requires an extension and or a deep socket to get into it. Its right next to the starter motor.

[vinnY]

yeah hopefully i can find it in the dark hey :p
if i do find a pic though i'll answer myself here