EG rails/DA9 rails

[DA9B18C]

Im new to EG, so if there is a interchangable parts thread i should read, please send it my way.

but for now

Will Da9 integra rails fit into an eg?, if not is there a DIY to change the seats or what seats (front and rears) bolt directly into an eg.

thanks guys

[jdm_b16a]

Here are some seat dimensions:

EK & EG Civics (Hatch & Sedan): 430mm
DA9 Integra - 405mm
ED6 Civic - 330mm
ED3 Sedan - 445mm
Concerto - 445mm
CB7 Accord - 450mm
BA4 Prelude - 425mm

This is the width between the mounting points on the rails. So to answer you're question, it would not be a direct swap. You would need to do some cutting and welding. Looks like the Prelude is a closer fit.

Peter

[DA9B18C]

thanks for the info,

so how do they straight swap dc2r rear seats into the EG. and arent dc2 seats ment to go straight into an EG??

im confused. any DIY??

[jdm_b16a]

thanks for the info,

so how do they straight swap dc2r rear seats into the EG. and arent dc2 seats ment to go straight into an EG??

im confused. any DIY??

Don't know. Its possible but I've not measured any DC2s. someone with more experience with that model might give you a definitive answer.

Peter

[DA9B18C]

cheers again, NE1 know

[DA9B18C]

some one needs to know, who out there has put DC2r rear seats in their EG???

[BaNaNaMaN]

OK, here is how it works out.

EG is compatible with DC but you must use the DC seat rails and bolt the whole seat/rail in.

As for the back it depends on your car.

Civic Hatch fits ITR rear uprights and lower seat but the DB8R lower fits better
Civic Sedan only fits DB8R upper and lower

Now by that ordinary DB and DC seats are the same as the type R versions just different materials.

[Paul1985]

As mentioned above.
The DC2 front seats will fit an EG.

DA9 and DC2 are a different car... I havent tried fitting EG seats to DA9 so i wouldnt know about that one.

[Paul1985]

BTW, try this threar for all your DA9 info:
http://www.ozhonda.com/forum/showthread.php?t=81824

[cymax]

OK, here is how it works out.

EG is compatible with DC but you must use the DC seat rails and bolt the whole seat/rail in.

As for the back it depends on your car.

Civic Hatch fits ITR rear uprights and lower seat but the DB8R lower fits better
Civic Sedan only fits DB8R upper and lower

Now by that ordinary DB and DC seats are the same as the type R versions just different materials.
To further add on to that, if you use DC2/DC2R rear seat on your EG, there'll be a gap between the uprights and lower seat.

front is basically bolt on.

[BaNaNaMaN]

You will only get that gap if you use the DC / DC2R lower seat. If you use DB / DB8R lower seat you won't get the gap.

http://i39.photobucket.com/albums/e182/Bananaman_666/_DSC8470.jpg
DB8R rears in my sedan. Before anyone else asks where I got them I am in New Zealand so these bits are a little more common. Still waited 2 years to find them tho.

[DA9B18C]

wicked, finally someone knows what im asking.

thanks guys