View Full Version : EK lca torque specs
simonnowis
12-09-2009, 08:30 PM
Hi,
What are the torque specs for the rear lca bolts?
also iv been tightening the lca bolts while its lifted up, but i came across some threads saying it must be tightened while under load. would it cause any problems if i didnt tighten underload?
Thanks
mocchi
12-09-2009, 08:48 PM
gonna break the torque maybe? cos the lca gonna move when on load.
54nm/5.5kgfm/40lbft
all three bolts. to subframe, to suspension and to trailing arm.
simonnowis
12-09-2009, 08:56 PM
thanks, found the answer.
mocchi
12-09-2009, 08:58 PM
thanks, found the answer.
to why we should torque the bolts under load? TELL MEEEE lol
simonnowis
12-09-2009, 09:05 PM
bushes may wear out faster without load, no biggie prob will just undo and retighten while its not lifted.
string
13-09-2009, 02:40 AM
They will wear much faster if they're preloaded since they'll be twisting by a larger angle. Old rubber bushings get used to the movements like an good pair of jeans. If they're older or on their last legs, preloading might rip them apart completely.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.