shurman
16-09-2009, 04:17 PM
Hello people.
I am after some advice, do's, don'ts or anything in between.
I just bought another ek civic and it has the rear interior panels removed due to the fact it has a rear strut. I want the panels back in for a neater look. The only way I'm going to get those panels back in is to cut them... I think. So before I go hacking my plastic to millions of uneven pieces I thought I would check here. I was going to measure it up the best I could and mark it out and cut conservatively with a hack saw, then trial fit, go back take a bit more off.
Anyone been through this? and found a good solution or method?
I can post pic's later if what I'm asking is unclear due to my well below average english.
cheers fellas
I am after some advice, do's, don'ts or anything in between.
I just bought another ek civic and it has the rear interior panels removed due to the fact it has a rear strut. I want the panels back in for a neater look. The only way I'm going to get those panels back in is to cut them... I think. So before I go hacking my plastic to millions of uneven pieces I thought I would check here. I was going to measure it up the best I could and mark it out and cut conservatively with a hack saw, then trial fit, go back take a bit more off.
Anyone been through this? and found a good solution or method?
I can post pic's later if what I'm asking is unclear due to my well below average english.
cheers fellas