View Full Version : DC2R strut bar into EG
im.Kusuma
14-10-2009, 10:26 PM
SOrry if this topic has been mentioned before, im just after a quick reply..
I got a DC2R strut bar lying at home and i wanted to put it in my EG.. wud the process be bolt on or mods are needed? thanks.
SiReal
14-10-2009, 10:28 PM
bolt on, just add nuts and bolts to the pre-drilled holes and off u go.
if no pre-drilled holes, drill, then add nuts and bolts.
mates eg5 vti had predrilled holes fYI
look at a dc2r engine bay - that shoudl give u an idea of where it should bolt onto. - chassis brace, not a strut brace.
im.Kusuma
14-10-2009, 10:43 PM
bolt on, just add nuts and bolts to the pre-drilled holes and off u go.
if no pre-drilled holes, drill, then add nuts and bolts.
mates eg5 vti had predrilled holes fYI
look at a dc2r engine bay - that shoudl give u an idea of where it should bolt onto. - chassis brace, not a strut brace.
cheers for that mate. totally understood. thx.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.