View Full Version : conversion question
jonniesz
08-11-2009, 11:13 PM
hey guys i have an eg but its been front ended before, and i want to chuck in a b16 or b18, should i attempt it ?
hisoka
08-11-2009, 11:25 PM
is the front end damage repaired yet or not ? i dont see why you shouldnt attempt it lol~
kcokla
08-11-2009, 11:44 PM
dpends how bad the damage is.
make sure its still straight and go for your life!
hisoka
08-11-2009, 11:46 PM
i think in the workshop manual it shows you the points, and u just measure them and check the lengths, and if its the same it means body is still sitting straight.
nissan ones have it, iam pretty sure honda ones do too ? anyone
jonniesz
09-11-2009, 12:01 AM
umm its been repaired, but not sure if engine bay is straight should i just ask my panel beater ?
hisoka
09-11-2009, 12:06 AM
yeah i guess. or just sell it and buy a new one lol
grifty
09-11-2009, 12:46 AM
how bad was the damage? radiator support changed over?
kcokla
09-11-2009, 09:03 AM
do the measurements, and get as strut bar (f rnot) and check if its fit right.
i remember helping benjamin on a car and we spent 20 minutes trying to get the strut bar in only to figure out that it was bent and we couldnt put it in
EK1.6LCIV
09-11-2009, 09:18 AM
the haynes book should talk it up
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.