Rsm + Rpm

[[stealth]]

Just installed a Apexi Gen II RSM today into my gen 5 prelude vtir..

and I think my RPM is not aligned or reading right on the unit or vice versa... also... is the RPM on a 5th Gen meant to read as low as.. 450-500... at idle(reading from the unit)??? Dunno if thats normal.. but I thought it was meant to be around 785-850ish etc..

So say I rev the car.. according to my dials... to 2kRPM... on the rsm it shows up.. about 1.2krpm.. so what could be the problem.. anyone know?

[dundas]

ill look on sat 4 ya.

[EuroAccord13]

In your RSM settings, your pulses must have been set wrongly that is why it's not reading correctly... Play around with it and you will get it :)

[[stealth]]

how do u play around with these pulse settings and what should they be for.. 98 prelude..

cycl: 4
sp1: 4p
adj: 100% (wots this?)
tire: 100%
wght : 1500kg

this is just an example from the manual...

[ACTI0NMAN-1]

']how do u play around with these pulse settings and what should they be for.. 98 prelude..

cycl: 4
sp1: 4p
adj: 100% (wots this?)
tire: 100%
wght : 1500kg

this is just an example from the manual...

Thats for more fine tuning of the Signal Pulse (sp1).