ITR 5 Stud conversion questions, suspension

[GSi_PSi]

Hey guys im doing a 5 stud conversion to my integra
i have the front brake, calipers, rotors and subframe from the front
what do i need for the rear? can i use my gsi calipers for the rear if i get the rear hubs with rotors.. also i have my gsi suspension , lowered springs and shocks , are they interchangealble or do i have to buy type-R ones?. Also do i need new drive shafts >?

[G-Stick]

with the suspension, u can use ur current ones, just use the same lcas. not too sure with the calipers. heard u can use DC5R rear calipers

[GSi_PSi]

for both the rear and front lca? also are gsi rear brakes same size as dc2r?

[GSi_PSi]

bumppp

[G-Stick]

not too sure on the brakes. the front lcas are the same. u will be able to use ur current suspension as long as you use the same lca

[bennjamin]

sam this is what you need.

1. ITR front calipers + pads. These will bolt onto your existing knuckles and suspension , easy.
2. For the rear , just get the entire trailing arm set from a ITR. Or you can simply reuse your exisiting rear brakes they should be fine.

Upgrade your brake booster + master cylinder to a ITR sized unit ( 1 inch)

[GSi_PSi]

ben. i wanna convert to five stud rims aswell..will i need new suspension and driveshafts?

[cymax]

You should be able to use your existing driveshaft. Suspension will be the same as the front LCA is the same. As for the rear, it's all up to you. You can use the old rear LCA or you might want to upgrade to DC2R rear LCA so that you can use coilovers that are made for DC2R

[bennjamin]

ben. i wanna convert to five stud rims aswell..will i need new suspension and driveshafts?


ahh k sorry misread. Yes , ONTOP you need the 5 stud front n rear hubs. Whether the entire front knuckles too off a ITR -

[kaze]

crv front hub and knuckle are close to the itr. different bearing(outter race is ~2mm bigger) and hub(a little less wheel track), front calipers are the same tho.
you'll also need crv or itr driveshafts as the hubs are bigger.


rear needs the spindle, hub, brake brackets and brakes.
itr spindle and hubs are longer and wont fit the 32mm nut safely(not enough thread).

later modeled honda's have the same calipers as itr, they fit if you swap them left to right. bleed nipple will be upside down tho.