Just a quickie please.

[beeza]

Does anyone know if brembo slotted rear rotors would fit a 96EK1 civic?

It`s the one`s Vinny is selling here. (http://www.ozhonda.com/forum/showthread.php?t=124168)

And would they be a direct swap over,no tricks?

Thank U!!

:honda:

[Tarquin]

Does anyone know if brembo slotted rear rotors would fit a 96EK1 civic?

It`s the one`s Vinny is selling here. (http://www.ozhonda.com/forum/showthread.php?t=124168)

And would they be a direct swap over,no tricks?

Thank U!!

:honda:

DC2/4 uses same rear rotors as ek1, so shouldn't be a problem, checked DBA's catalogue at work and are same part numbers. I know DBA are not brembo but if one brand are making the same rotor for each they all should be

[Tarquin]

And Ive had slotted rotors on my old ek1, straight swap no mods needed. There all made for a specific application/s

[Mugen Civic]

given that the rotor size is 240mm and that your car already has rear disc (as some ek1 has rear drum brakes) its all good!

[vinnY]

sound's like a go
the rotor's made for the rear of a dc2
so specs should be something along the lines of:
diameter; 240mm
thickness; 9mm
min thickness; 8mm
height; 48mm
center bore; 64.1mm
4x100 bolt pattern(was originally going to redrill to 4x114.3 for my 96spec setup but i decided to go 262mm at the rear)

[beeza]

Sounds good Vin,PM`ed mate.