list of external oil seals...

[migoreng]

i just want to know where all the external oil seals are in my h22a...
i'll start off with what i know:

valve cover
spark hole seals
vtec solenoid gasket with mesh
oil pan gasket

rear main seal
distributor oil seal
cam seal/plug next to the distributor.
2x cam seals on the opposite side
crank seal
oil filter o ring

is there anything else?

[blk_shadow]

i just want to know where all the external oil seals are in my h22a...
i'll start off with what i know:

valve cover
spark hole seals
vtec solenoid gasket with mesh
oil pan gasket

rear main seal
distributor oil seal
cam seal/plug next to the distributor.
2x cam seals on the opposite side
crank seal
oil filter o ring

is there anything else?

oil pump seal and some models have balancer shaft seal as well, which common for leakage

[migoreng]

Q about the vtec gasket. mine is nearly a year old. if i remove the solenoid to clean the seal/mesh can it be reused?

i've got this problem.
http://i237.photobucket.com/albums/ff47/migoreng1/leak/DSC07268Large.jpg

if the solendoid seal is good then it can only be from the cam plug above right? my rocker cover was changed a few months ago during a major service which included timing belt/front seals etc...

[blk_shadow]

yeah, better check your cam end seal.

but ppl usually replace the vtec solenoid gasket rather than cleaning it and reuse it

[Sir_vtec]

lol if your going to take off the vtec solenoid, clean it and then reuse the seal then your gonna be cleaning that area again few months down the road so no point reusing the old seal. Get a new seal...