PDA

View Full Version : buddyclub spec6 cams b series


jetdc2R
26-12-2009, 04:00 PM
hey,



-can i run stock bottom end with the buddyclub spec 6 b series cams??


cheers
VTec1987
26-12-2009, 04:59 PM
dun think so buddy
buddy club 4 cams is already over kill for b18c7 motor
jetdc2R
26-12-2009, 05:12 PM
what can i do make my engine run those cams, i can get the head all done dual valve springs, retainers, valves, cam gears. what can i do to run them??
VTec1987
26-12-2009, 05:15 PM
increase your CR
beeza
26-12-2009, 06:13 PM
Damn,spec 6!!

I thought 4 was max!

Imagine the Idle!
jetdc2R
26-12-2009, 06:54 PM
increase your CR

if i buy a 2mm buddy club head gasket will it raise it enough to run those cams??
VTec1987
26-12-2009, 07:07 PM
it wont be enough man, recommended CR for BC4 is 12mm+, cant imagine BC6

BC3+ cam on b18c7 already shows some good gains

Check out Vinnys dyno graph

I havent seen anyone used bc4 cams on stock C7 motor yet,
Anyone out there tried it?
spardikis
27-12-2009, 08:30 AM
if i buy a 2mm buddy club head gasket will it raise it enough to run those cams??

2mm gasket lowers the compression... you want a single layer or double layer gasket to help.