em1/ek9 exhaust question

[VAT05]

hey guys and girls,

im looking at buying an exhaust from a fellow ozhonda member. (picture attached)http://i66.photobucket.com/albums/h272/2_and/ek9buddylcub.jpg

its made for a ek 4/9 would it fit an EM1?

i was under the impression that to fit a ek9 exhaust on a em1 the b pipe had to be extended. this system doesnt seem to have a b pipe?

any help would be appreciated.

thanks

[jks24]

hey guys and girls,

im looking at buying an exhaust from a fellow ozhonda member. (picture attached)http://i66.photobucket.com/albums/h272/2_and/ek9buddylcub.jpg

its made for a ek 4/9 would it fit an EM1?

i was under the impression that to fit a ek9 exhaust on a em1 the b pipe had to be extended. this system doesnt seem to have a b pipe?

any help would be appreciated.

thanks

an exhaust for an ek4/9 will be to short for your em1 you would need to modify it

Ive looked at modifying an exhaust for my car, imo its better just to buy a brand new one made to the right size from factory for your car.

Look at custom mate:thumbsup:

[CRXDEL501]

noope.

[EK9]

it will fit only with modifications to the axel back... EK and EM1 have the same wheel base, hence it'll go over/under the rear axel but the exhaust/tip will be too short... piping just needs to be extended.

your exhaust there would probably need more modification then normal, but if it had to be done i think it'll be just at the bend under the axel, extended and even re-angled. too much hassle for this type of exhaust i reckon.