Fitting Type R bootlid into Type S

[ob3d]

I've done a few searches but found no threads on this... but has anyone tried to fit a Type R bootlid + wing onto a Type S?

Is it a straight swap/fit?

And for reference, how much did/would it all cost?

[Jump]

why would you want to? if its just for the type r wing, you can swap that over without needing to swap the whole bootlid

[burak213]

Check
Clubrsx.com lots of diy over there for boot lid and wing conversion

[ob3d]

I wanted to swap the bootlid to avoid filling up the holes left behind by the Type S wing/lip on the boot.
But on that matter, is it possible to weld it up good to avoid water seeping through?

@burak, kk will do now. Thanks for the heads up.

[burak213]

wing/bootlid attachment (http://forums.clubrsx.com/attachment.php?attachmentid=312320&d=1222206873)


Here is an installation on the boot lid and wing for a A-spec RSX from the usa - link is from clubrsx.

Should give you a general idea.