fail attempt injen intake dc5r

[spastic]

ok so....

i bought an injen cai for mates bday. did everything myself with a help from a mate.
first time.

everything went so well until.... i snapped a plastic connecter. i didnt take photos but i took photos from a diy.
in this picture, i circled the piece i tried to pull out so hard it didnt wanna come out then when it came out, the other end snapped. the piece looks like a knob.
http://i270.photobucket.com/albums/jj81/alriight/11.jpg
is there any places i can get a replacement? wreckers?
this is what is suppose to look like if it was done properly
http://i270.photobucket.com/albums/jj81/alriight/22.jpg


and.. is it safe to be driving around with that hose disconnected.. thanks

[thegame888]

Take the one you have to repco or bursons (for size reference). They should have hosing like that.

[TONTON]

... just get a larger hose to go over it and a clamp...

[spastic]

nar thats not the problem though.. i dunno how to explain it .. i'll try draw a picture

[spastic]

http://i270.photobucket.com/albums/jj81/alriight/qq.png

[JohnO]

the hose that snapped or the connector?

[spastic]

connecter. now its gotta hole

[omgzilla]

Spray some lubricant between the hose and the fitting to loosen it up. Remove the fitting out of the hose by prying at it using a thin screwdriver.

Once it's out - glue it back on.

[spastic]

ya i used araldite and cable to hold it down, cheers guys

[thegame-01]

love your drawing :D