View Full Version : avalance 4 channel 800w amp
michael_antoi
16-12-2004, 02:41 PM
i just bought this amp and was wondering if it was possible to bridge all four channels.
would i need that much wrms to run my clarion pa12-s which is rated at 300w continuous output or would bridging 2 channels be fine?
the model number on the amp is av800
bumography
16-12-2004, 02:45 PM
it is possible
however,
only the rear channel has a low pass
only thing u can do is bridge your rear channel-->lowpass-->Clarion sub
the other two channels can just sit there or you can use for a pair of speakers
michael_antoi
16-12-2004, 03:03 PM
that's not bridging 4 channels.....is it?
bumography
16-12-2004, 03:06 PM
if your amp is a 4channel amp
u cannot bridge it to 1 channel
u can bridge it to 2 channels.
u can bridge the front channels, but in this case with this amp its pointless. unless you use an active low-pass filter,
and no, you cannot bridge all 4 channels to this one sub. (assuming its SVC 4ohm)
michael_antoi
16-12-2004, 06:10 PM
ok thanks for that....
i'm just gonna bridge 2 channels and run my sub off that...
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.