E-manage Ultimate correct Jumper settings and problems with temp. gauge ?

[HondaRacer]

I have such e-manage jumper settings:
JP01 – open
JP02 – open
JP03 – open
JP04 – open
JP05 – open
JP06 – open
JP07 – 1-2
JP08 – 1-2
JP09 – open
JP10 – 2-3
JP11 – open
JP12 – open
JP13 – closed
JP14 – closed
JP15 – 1-2
JP16 – 2-3
JP17 – closed
JP18 – open
JP19 – closed
JP20 – closed

In Parameter settigs -- CH settings selected HN_WT-1 temp sensor, maybe it should be HN_WT-2 ? (and then JP13 and JP14 open). My temp gauge show incorrectly, idles ~ 900 when engine hot.
Who has E-manage Ultimate, what yours temp gauge readings ? how about idle ? You JP13 and JP14 open or closed ?

[HondaRacer]

who can check ?

[Crapdaz]

Are you running Greddy Emanage ult already? tuned file?

I can vaguely remember my car ran idle 900rpm after tune.
my temp gauge was normal, if you don't have a tune file i can send you a stock one that someone gave me.

[HondaRacer]

I have good tune file (tuned on dyno), all sorted out. Idles as stock ;) Thanks for help.

[sodaz]

Hi mate, I've got the exact same problem as you with the same jumper settings. Can you please enlighten me on how you fixed it?

[HondaRacer]

Hi mate, I've got the exact same problem as you with the same jumper settings. Can you please enlighten me on how you fixed it?

make
JP13 – open
JP14 – open
;)

[sodaz]

Thanks I will give it a try. :)

Dang...I can't open the bottom two screws. They seem to be JIS screws. :T

[HondaRacer]

Thanks I will give it a try. :)

Dang...I can't open the bottom two screws. They seem to be JIS screws. :T

you can drill carefully screw head.

[sodaz]

you can drill carefully screw head.

You mean modify the screwhead by drilling it a bit?

[HondaRacer]

I mean drill off screw heads if you cant open.

[sodaz]

I think I'll just go back to the tuner this weekend and get them to remove it for me.

Thanks again for your help. :)

[sodaz]

Thanks again HondaRacer. Changed jumpers and temp displays are all good now.