View Full Version : K20A head on k24a block
Just wondering if it would be worth the cost of putting a k20a head off either a integra type r or a ep3r on the k24a? Has anyone looked into this or actually done it? Thanks guys.
xntrik
09-05-2010, 03:02 AM
Wrong section.
Unless something is wrong with your K20A I wouldn't do it,
Rather just complete K24. or Complete K20.
In terms of value doing it from scratch, no.
K24 Block = ~$2000. K20 Block = ~$5000.
The only reason why you would do this is,
If you had a K20A blew the block, salvage the head and whack it on-top of a K24 bottom end.
Benefits? Not much I don't think.
Correct me if I am wrong.
pure_na
09-05-2010, 03:11 AM
yes, it has been done. i have no idea if it's worth it over building a k24, but i'm fairly sure a built k20/k24 > a built k20. as above, feel free to corect me as i have never done it.
Ah k thanks guys prob not worth the cost. Sorry what section should this go under? Technical?
aaronng
09-05-2010, 11:35 AM
What car do you plan to do this to? Technical would describe just the engine, while us in the Accord Euro section would tell you to save up another $5000-8000 for an aftermarket ECU that works with the Euro. Slapping the head of a k20a into an Euro and trying to drive without an aftermarket ECU would just give you a nicely damaged engine.
Planning to do this to a Euro. But not really worth it looking at those costs. Thanks Guys
integral90
14-05-2010, 12:50 AM
You'd really only swap the K20 head on as a preliminary step for a serious engine build
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.