Eskimo_firefighter
06-06-2010, 04:55 PM
Hi, i finally got around to installing my buddyclub racing spec coilovers. However, the front left wheel has some serious toe out angle and my front right is straight with abit of camber. My mech speculates that these coilovers i bought arent even for my car as the suspension geometry changed drastically, and in addition to adjust the toe angle back to normal would need to wind up the tie rods so much to the point of being dangerous, due to little thread left on the tie rod (about 3mm left my mech says).
I have put back on my stock suspension. And now contemplating on what i should do with these buddyclub rsd.
Now my question is. What should i do now? Any suggestions from you if you were in my position is helpful, because i dont know what to do with these coilovers.
Thanks
also i bought these coilovers on ozhonda second hand.
I have put back on my stock suspension. And now contemplating on what i should do with these buddyclub rsd.
Now my question is. What should i do now? Any suggestions from you if you were in my position is helpful, because i dont know what to do with these coilovers.
Thanks
also i bought these coilovers on ozhonda second hand.