oxygen sensor colour on ecu, JDM ITR

[Alexplicit]

i did have a search i couldnt find exactly what wire it was on the ecu :( im hooking up a narrow band. yes i know there not acurate but its all i got

[RandyRhydah]

http://www.ff-squad.com/technet/wiring/obd2a/obd2a.pin.schematics.gif

[Alexplicit]

sorry to sound like a noob... but still which colour is it i see several 02 sensor colours

[ECU-MAN]

dont go by colour


go by the above D connector Pin 7

O2 signal is usually white

[Alexplicit]

thankyou :)

[Alexplicit]

hey everyone i found a white wire. it has gold or yellow rings around it but not stripes just white and the sensor stil doesnt work. im a mechanic.. but im no good with electrics :( its something im working on. the gauge i brand new. not saying its not defective.. but yeah.

its sitting as low as it does when its off (the pointer is right on lean) i know it runs lean when there is no pressure on engine. and i havnt moved it since being connected. so im wondering if it is working or not.

[ECU-MAN]

are you allow the engine to warm up when testing.

O2 sensors only work when they have warmed up, the sensor in yor car has a heater to help it warm up quicker

[Alexplicit]

oh ok... i also found another wire. which has been splited with a red connector. it is connected to a blue with white stripe. on the wire connnected there is a little tag but it is japenese any ideas what this could be

[RandyRhydah]

use the image i posted and work out which wire it is you want connector D pin 7

[Alexplicit]

just a bump on this got the right wire... pretty sure :P... but the gauge seems a little eratic... up down up down.. responds when i put my foot on the gas .. but eehhh

[ECU-MAN]

that is what it it ment to do.

the ECU is controlling the mixture

[Alexplicit]

oh so its suppose to constantly erratically move around.. i thouhgt it stayed pretty consistant.... like lean at idle heavy foot would be rich and crusing would stay around the middle.. mine just constantly jumps around everywhere