D-tech heads - A6 cam in the Y4 head?!

[VTECnique]

After looking at this page (http://en.wikipedia.org/wiki/Honda_D_engine) (near the bottom under SOHC ZC) & also this page (http://www.d-series.org/forums/engine-building/45263-d16a6-d16y4-question-helpppp.html), it got me thinking, could i swap an A6 cam in the Y4 head. I cannot seem to find Y4 cam specs anywhere, so i could compare the 2. Alot of the yanks use the A6 cam as a low-budget upgrade, so im wondering if i can do the same thing. Only problem is, there's no A6's in OZ, & if by some chance it doesnt fit then im outta pocket quite a bit from the massive shipping cost of a camshaft from yankland....

[dougie_504]

I think The Saint did something like this, can't remember if he used Z6 or A6 though. Check out his build thread in the Build section.

[grifty]

D16Z2 is the same motor as the D16A6 meaning that you will be able to find a cam here in Aus.

[xclusive_eg8]

the saint used a a6 cam on d15b7 ;)

[VTECnique]

great, so does anyone have cam specs for the D16Y4?!