:( NEED HELP!!can't remove the rear lisence plate holder from EK ??

[wtfalfred]

How can I remove the plate holder??:confused::confused::confused:
I can't find any screws -.-
Heres the picture from my EK.

So i think there were a few screws behind number plate,

but i can't even remove the number plate.
please help..:(:(:(:(

[na-118]

ya might have to remove the number plate before you can take that insert out

[wtfalfred]

yeah, im going to remove the number plate, but i can't take it out..

[wtfalfred]

any one help ???

[Boban]

take your plate off, wriggle the plastic plate surround (robert lane honda thing) that's what's wedging it in and than there are 2 plastic screws op top and 3 clips from memory down on the bottom of the black plastic surround holding it onto the hatch

[Jye]

I'm having same problem. There is a clear cover and black plastic trimming. I would like to remove it as the front doesn't have any cover.

[Jye]

I just got mine off. I had two clips on both sides which slide off the ends. Doesn't look like your one has the clips. Then I had to pull the cover and plastic surround off the license plate as it was stuck on with adhesive. Then your just left with the number plate which is screwed onto the car.

[raniti]

if you want to do it the long way...
first you take off the plate.
second there are 3 screws on the top
third take off the inner lining of the boot, there will
be a nut on the right and side, undo the
fourth should just come off with a little pull.

thats what i did anyway, didnt know about the nut until i put it back on after the 4th time
i kept getting boot rettle so yea