abs wheel speed sensors, space between the wss and the pulser ring

[vinnY]

if the gap exceeds the limits(0.4-1mm) would it throw codes 12, 14 or 18? i.e. wss electrical noise/intermittent interuption

[ECU-MAN]

it can do

not so much noise but intermittent or interupted operation

[vinnY]

interesting, tried sensors from ek4/dc2r/ek9 and all but one seem to throw a code(appears to be the ones with the largest gap, pretty obvious ones too i.e. 3-4mm)
any harm in shaving down the mounting points a bit to get the sensors closer?

[ECU-MAN]

from a safety perspective I would not advise it, but it would work if the wss is the same resistance as the original.

I dont see how Milling the mount could pose any danger but it could weaken the knuck if done wrong.

[vinnY]

i'd probably mill down the mount on the sensor itself with a hand file to not damage the wiring
i'll see how i go and report my results

as for abs sensors, i've measured the resistance from all of them and they appear to carry the same resistance throughout the range

[ECU-MAN]

should work that way then

good luck, if you have success with it, post your results here

[vinnY]

for the sake of interest, i hacked down the wss's seat with a hacksaw until it was within factory spec
happy to report, i have abs again

[ECU-MAN]

good stuff

[vinnY]

just an update, definitely fixed the problem
abs still works and the light is staying off

dash looks a bit lonely now though without the light there :p