External Coil install

[Limbo]

Hi All
Looking at doing an external coil, previously when i installed one, i opened the dizzy and took the 2 wires from the coil and soldiered them to the new wires i setup.

Now i was thinking to make it easier i can just pickup the 2 wires from the distributor plug, unpin them from the loom & then pin in the ones i want. This will make it a cleaner job i would have thought.
Anyone able to tell me which ones are the 2 wires for the coil? I've got an obd2a Dizzy.

I know i can always open it up and look it up but i'm hoping not to have to do that.

I know CRXer was good at these things, ECUMAN?

P.S any pics would be awesome also

[ECU-MAN]

you wont find what you need on the outside of the coil, this is because the the ICM is inside the dizzy and there is a wire that goes from the ICM to the coil ( - ). so yo need to run that wire out of the dizzy to the new coil along with the power to the coil ( this one is found on the outside but also needs to power the ICM as well )