Spacers

[raffyboy]

Hi All
Anyone here uses 25mm spacers? I need for my rear - where to buy?

[x10Hz]

try google dude...
just make sure u get hub-centric spacers

[namtaro]

tranz does, dont know if hes on here often, he ran 25mm spacers all round for ages with his old setup.

[ricerockets]

i run 25mm bolt on spacers on the rears

i got cheapy ebay ones paid about 150 from memory, word of warning though my ones had pretty bad quality studs on it, so far ive replaced three studs out of ten because i snapped them while undoing the wheel

and yes do try to get hubcentric ones

[namtaro]

well tranz had hks ones and are hubcentric hence why he had no problems, so get hubcentric

[raffyboy]

Thanks guys

one more question what's the Hub centric measurement for CL9 and the stud thread measurements?

I got an email from a supplier and these are his questions

Hi, we only stock the Nissan hub centric spacers. Please make sure these spacers will suit your hub/inside wheel (72mm). Also the thread pitch is 12x1.25

[ricerockets]

i think thread pitch for hondas is 12x1.5, while i think it was a 64mm hub centre but dont quote me on that quite yet, ill do some more research once i get settled into my next class

[TRaNz]

Close Namtaro....=p
I ran genuine H&R spacers on my previous wheels. Yeah it was 12x1.5 and centre bore was like 64mm.
They were adpater spacers not slip ons of course, so i didnt have to get the studs replaced or made longer.
I got the from KingMotorSports in the US for like just under 170 to my door.