b16 from em1 into eg5

[ucme]

hey guys

i tried to search for some info but fell short of what i need.

im confused about using a eg5 harness for a b16a out of a em1 which i think should be a 0bd02b?

also will i need to get some eg specific mounts or would they fit? also if i dont plan to change my front brakes what are my options with the drive shafts? thanks

[Tai]

You need specific mounts from DC2 or EG or Del sol CRX for B series.


EM1 is ODB2B where as EG is ODB1 off memory

You should upgrade the brakes but its not needed for rego to pass.

Drive shafts can be used from EM1 to your EG.

[Mugen_R]

You would need a DC2 loom + EG\Dc beseries rear bracket and other DC2 mounts to fit in ur eg.

You would need a obd1 ecu

[ucme]

So it would be much easier to source a obd1 b18c from a dc2 vtir