Cracked lip

[BennyH]

I have a rear lip on my EK, and driving with speedhumps every 2 metres stuffed up my lip. Went a bit fast on one and resulted in cracking the rear lip. Anyone got any suggestions on fixing this ?

[dougie_504]

You could try contacting a plastic welder, but this isn't cheap. If it's a replica lip that you can replace easily then I would consider doing so as you'll probably spend more getting it plastic welded.

[jeremydawg]

you could do a quick job and fiberglass it, youd have to sand and respray though for it to be done properly. might not be worth it if its a replica as mentioned

[blastnpast]

I snapped my rear lip and front lip paid to get them
Both repaired and painted and funny enough they snapped while I was installing...

That was the day I learnt once its broken just replace them

[dougie_504]

Yep. A good quality one will flex a lot more than those hard/brittle ABS plastic replicas. You get what you pay for, as they say...

[NeedVtec]

If you dont care too much about looks, just drill holes on both sides of the crack, and put cable ties through them

[mooshie]

A quick search came up with this-

http://www.ozhonda.com/forum/showthread.php?105990-DIY-Repairing-and-respraying-cracked-plastic-lips&highlight=repairing%20cracked%20lip

Q-Bond is available at Repco and about $20-$30 from memory.