Machining/ re-threadding specialist in melbourne

[cheapdouchebag]

Good evening,
I am looking for a machinist or someone that can rethread my gear knob ive just purchased
The threading comes as 12M x 1.25P (metric)

Can someone recomend where i can get that rethreaded to 10M x 1.5P metric or add/remove something to make it 10m x 1.5P? in melbourne. and if possible, can someone tell me how much i am looking at spending? (im a uni student so im counting my pennies so i gotta get ready to have enough)
cheers in advance.

[MWAKU]

yellowpage it

[cheapdouchebag]

i hope i dont sound like a dumass but what would i look at it under? i typed in machining in yellow pages and it comes up 'plastic machining industrial grade' or whatnot.

[mugen_ctr]

If ur uni has a engineering department or so, ask around, they have all the thread making tools u need, as far as thread making companies, ur best bet is to ask bolt shops, an go from there

Most places that do machining should do threading as well

[crobaa]

Any engineering shop should be able to do it for you, just gotta find one thats willing to take on such a small job. The labor cost is probably going to be similar to the cost of a new gearnob though

[Snoop_gee]

The Thread Doctor

http://file.seekpart.com/productsimage/2011/5/12/2011512234045375.jpg

4 Floral Gardns, Narre Warren South VIC 3805, Australia

Mob:0419 507 633