dc2 vtir into an EG

[flipmode]

hi guys, I was wondering what other parts of a dc2 vtir are capable of and worth-while fitting into an EG.

Other than the engine swap and all the other regular parts changed during a conversion, what else would fit into an EG?

I've heard the dash fits in but requires a bit of modification.

Also, would aftermarket coilovers for the dc2 fit into an EG without any further components?

Any info would be great, cheers

[duzy]

You can take the front and rear brake setup along with the master cylinder if needed. Front and rear seats, rear seats require a little modding.

The dash im not sure but there was a DIY thread on here and it involved alot of modding (cutting and trimming etc) Door trims wont fit aswell.

Aftermarket coilovers should be fine as long as the rears are fork type.

[javer81]

almost any mechanical parts are transferable to an EG. they share a same base chassis. from the crossmember subframe bar, steering column, steering wheel. front and rear sway bars. brakes. cosmetic and interior might need some modification. not bolt on.

[TheSaint]

dash, front seats, sunroof, wheels, hubs/brakes, rear swaybar, front upper chassis brace, rear seats (eg hatch only)

[flipmode]

sounds good thanks for your help guys

[najdi]

Go all out n do a front end conversion will need a pro to do it tho

[trism]

http://www.superhonda.com/photopost/data/501/29950wetoddimage.jpg

[EG52NV]

http://www.superhonda.com/photopost/data/501/29950wetoddimage.jpg

That looks ridiculous Hahahaha

[flipmode]

hahaha yeah prob look even worse with my AUSDM front end

[TheSaint]

its the only one that really looks ok - the audm/usdm and prelude conversions are worse lol