Import HID lights on EU Civic

[tinytonez]

Hi guys,

I came across this site while trying to search for some answers. I hope you guys can help.

I am replacing my headlights on a 2002 EU Civic as the old ones were damaged and the new ones are actually imported headlights that comes with the HID ballast. My question is how do I rewire it to the stock wiring harness? There is a plug from the ballast with 2 wires (red and black), can I just connect it to any power and ground? I have some pics that might help

This is the plug that I'm not too sure what to do with. I have the other plug that plugs into it, but not too sure where to wire it to
http://img809.imageshack.us/img809/7923/71984526.jpg

These 2 pics are the main light plug, but my current light plug would not fit it. I do have the correct fitting plug but it needs to be re-wired and I'm not too sure how to go about it
http://img42.imageshack.us/img42/8739/26514126.jpg
http://img695.imageshack.us/img695/6052/42322863.jpg

This is my current light plug. It has 3 prongs, and it is a totally different plug to the on in the above 2 pics
http://img541.imageshack.us/img541/5947/41511467.jpg

[tinytonez]

Any ideas??

[Grayfox]

You're light plug looks like a H4

The first pic looks like the connector is comming from the ballast.
do you have the cable that goes between them?

.......Full beam
.............|
Ground--|--Dipped Beam

is the most likely pin layout on it.

[tinytonez]

So from the H4 plug I just run it straight to the ballast? Don't need to use the plug in the 2nd and 3rd pic?

[Grayfox]

If you have that small cable you just plug it from the ballast and connect it to the other plug on the same side.