Intake problem

[dc2screama]

Got a small problem, l picked up my new intake this arvo, l got all the brackets and clamps and that bit of hose you connect to the rocker cover to the intake piping. My question is if l connect the hose to the rocker cover and piping what am l suppose to do with the previous one. Leave it sitting there? And btw its a b18c2 integra Thanks guys

[glen06]

http://sphotos.ak.fbcdn.net/hphotos-ak-ash1/hs786.ash1/167640_10150128996350011_628000010_8376000_2048544 _n.jpg

just look at that set up.. normaly i think they only have 1 hose from Intake and going to ROCKER cover.. hope it helps yah

[dc2screama]

Lol mate l no where to connect it, what happens to the previous piping that was originally there. Leave it hanging?

[TheSaint]

i know what you mean - its setup like a harness with a metal coolant line and metal breather line all in one
usually intake kits come with enough hose so that you can remove the entire harness and re-route the cooling line so its just a bit of hose instead of metal hoses

intake kits like Fujita/Injen even come with instructions on how to do this - but cheaper kits dont

just get some coolant hose from an auto store (if you dont already have some) and replace the harness with a single peice of hose
sometimes theres even enough hose on the stock lines to plum them back in after you remove the metal hoses
do it when the car is dead cold and dont forget to get the bubbles out of your coolant when your done

[dc2screama]

Thanks man, just another question how do you get rid of the bubbles?

[TheSaint]

http://www.google.com.au/#hl=en&source=hp&q=how+to+get+rid+of+bubbles+in+coolant&oq=how+to+get+rid+of+bubbles+in+coolant&aq=f&aqi=&aql=undefined&gs_sm=e&gs_upl=1372l9067l0l46l36l4l6l3l2l357l5085l2.14.7.3 l26&bav=on.2,or.r_gc.r_pw.&fp=2d8ca68137622c71&biw=1680&bih=920